WorkspaceManager_Err-GlobalPowerObjectScopeChangesGlobal Power-Object Scope Changes_AD

您正在阅读的是 17.1. 版本。关于最新版本,请前往 WorkspaceManager_Err-GlobalPowerObjectScopeChanges((Global Power-Object Scope Changes))_AD 阅读 21 版本
Applies to Altium Designer versions: 15.1, 16.0, 16.1, 17.0 and 17.1
 

Parent category: Violations Associated with Nets

Default report mode:

Summary

This violation occurs when a port-based object (port, offsheet connector, NanoBoard Port-Plugin component) has been connected to a power port object. The power object can no longer exist on a global level - connected to a global power net - and is instead changed to be a local-level power net.

Notification

If compiler errors and warnings are enabled for display on the schematic (enabled on the Schematic - Compiler page of the Preferences dialog) an offending object will display a colored squiggle beneath it. A notification is also displayed in the Messages panel in the following format:

Global Power-Object <NetName> at <Location1> has been reduced to local level by presence of port at <Location2>

where:

  • NetName is the net to which the power port object is associated.
  • Location1 is the X,Y coordinates for the power port object's electrical hotspot.
  • Location2 is the X,Y coordinates for the port object's electrical hotspot.

Recommendation for Resolution

This violation can typically arise when a power port object is incorrectly wired to a port rather than the intended pin or sheet entry. There may however be cases where you wish to force (and use) a scope change of this kind. With the violation selected in the Messages panel, use the Details region of the panel to quickly cross probe to the offending objects. Assess whether the connection between port and power port is intended and, if not, remove the power port and wire the remaining port object to its intended destination as required.

 

可用的功能取决于您的 Altium Designer 软件订阅级别

Content