Altium Designer Documentation

Configuring Schematic Signal Harness Object Properties in Altium Designer

Created: September 27, 2019 | Updated: October 17, 2019
All Contents

Parent page: Signal Harness

Schematic Editor object properties are definable options that specify the visual style, content and behavior of the placed object. The property settings for each type of object are defined in two different ways:

  • Pre-placement settings – most Signal Harness object properties, or those that can logically be pre-defined, are available as editable default settings on the Schematic - Defaults page of the Preferences dialog (accessed from the  button at the top-right of the workspace). Select the object in the Primitive List to reveal its options on the right.

  • Post-placement settings – all Signal Harness object properties are available for editing in the Signal Harness dialog and the Properties panel when a placed Signal Harness is selected in the workspace.

            

If the Double Click Runs Interactive Properties option is disabled (default) on the Schematic - Graphical Editing page of the Preferences dialog, when the primitive is double-clicked or you right-click on a selected primitive then choose Properties, the dialog will open. When the Double Click Runs Interactive Properties option is enabled, the Properties panel will open. 
While the options are the same in the dialog and the panel, the order and placement of the options may differ slightly. 

In the below properties listing, options that are not available as default settings in the Preferences dialog are noted as "Properties panel only".

Properties

  • Width - use the drop-down to select the default width from the available choices: SmallestSmallMedium, and Large. Click on the color box to access a drop-down from which you can select the default color.

Vertices (Properties panel only)

  • Grid - lists all of the vertex points currently defined for the object in terms of:
    • Index - the assigned index of the vertex (non-editable).
    • X - the X (horizontal) coordinate for the vertex. Click to edit.
    • Y - the Y (vertical) coordinate for the vertex. Click to edit.
  • Add - click to add a new vertex point. The new vertex will be added below the currently focused vertex entry and will initially have the same X, Y coordinates as the focused entry. Click  to remove the currently selected vertex.
Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: