PCB_Dlg-DrillPairFormDrill-Pair Properties_AD

This document is no longer available beyond version 18.1. Information can now be found here: Defining Blind, Buried & Micro Vias for version 24

Applies to Altium Designer version: 18.0

The Drill-Pair Properties dialogThe Drill-Pair Properties dialog

Summary

The Drill-Pair Properties dialog provides controls to configure a drill pair for the active layer stack in terms of start and stop layers. Drill pairs must be configured when blind, buried, or build-up type vias are to be used, with a drill pair for each layer-pair that a via spans. The dialog is also used for defining back drill start stop layers for a design that uses back drilling.

Access

The dialog is accessed from the PCB Editor through the Drill-Pair Manager dialog in the following ways:

  • Click the Add button.
  • Select a currently-defined drill pair (other than the Top Layer - Bottom Layer drill pair when the active stack is the default Board Layer Stack, which cannot be edited) then click the Drill Pair Properties button.
The Drill-Pair Manager dialog is accessed by clicking the Drill Pairs button in the Layer Stack Manager dialog. The latter is accessed by clicking Design » Layer Stack Manager from the main menus.

Options/Controls

  • Drill-Pair Properties - the following fields collectively define the drill pair:
    • Start Layer - the start layer for the pair. Choose from any of the currently defined signal and plane layers for the board as configured and enabled in the active layer stackup.
    • Stop Layer - the stop layer for the pair. Choose from any of the currently defined signal and plane layers for the board as configured and enabled in the active layer stackup.
    • Back drill pair - enable this option to define this pairing of start and stop layers as the layers that will potentially be back-drilled through. One of the Start/Stop layers must be a surface layer (Top Layer or Bottom Layer); the other layer can be any internal layer. To learn more about back drilling, refer to the Controlled Depth Drilling, or Back Drilling article.

Tips

  • Drill pairs must be defined to suit the layer stack-up style. This should be done in consultation with your board manufacturer to ensure that your design matches their fabrication technology.

 

注記

利用できる機能は、Altium Designer ソフトウェア サブスクリプション のレベルによって異なります。