MCAD Fusion 360: Bad performance with the boards with 500+ components

Created: September 23, 2021 | Updated: September 23, 2021

This is a known issue with Fusion (reported for all big assemblies, not only with the ones built by CoDesigner.)

Starting in Version: 20.1
Up to Version: Current

Solution Details

As an alternative approach, we provide a way to disable the placement of small components (in most cases, they are not important for the mechanical design). See this documentation:!support-for-fusion-360-to-ignore-small-components
Was this article helpful?
Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: