PCB_Cmd-RemoveCoverlayRegionRemoveCoverlayRegion_AD

Created: 1月 19, 2023 | Updated: 1月 19, 2023

The following pre-packaged resources, derived from this base command, are available:

Applied Parameters: None

Summary

This command is used to remove a coverlay region.

Access

The command is accessed from the PCB editor in Board Planning Mode by right-clicking over a Flex coverlay region then choosing Coverlay Actions » Remove Coverlay. The required coverlay layer must be the active layer in the main design space.

The current viewing mode for the PCB document can be changed using the corresponding commands from the main View menu. To switch to Board Planning Mode, use the command of the same name, or use the 1 keyboard shortcut.

Use

First, ensure that a coverlay region is present on the PCB. After launching the command, the coverlay region will be removed.