Skip to main content

Ver: Version: 21

Ver: Version: 21

Ver: Version: 21

Close

Search Search on Documentation

Altium Designer Documentation

Documentation

Altium Designer Documentation ... Command Reference ConstraintsManager Commands

SwitchMeasurement

Created: December 21, 2020 | Updated: January 12, 2021

Parent page: ConstraintsManager Commands

The following pre-packaged resource, derived from this base command, is available:

Switch Measurement

Applied Parameters: Index=%1

Summary

This command is used to change the measurement units in the Rules Editor.

Access

This command can be accessed from the Rules Editor by choosing Tools » Measurement Units then selecting the desired unit of measure. Choose from mil and mm.

Use

After the command is launched, the measurement units in the Rules Editor change to the unit that was selected.

Note

This documentation page contains information for an older version of Altium Designer. The latest, online documentation can be found here.