ConstraintsManagerObjectInspector

Created: March 18, 2021 | Updated: March 22, 2021

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: Action=Toggle|SetFocus=True

Summary

This command allows you to quickly toggle the display of the Advanced constraints options mode of the Properties panel.

This command can be accessed from the Constraints Editor by using the F11 keyboard shortcut.

Note that you must Switch to Document View in the PCB Rules and Constraints Editor to access the Constraints Editor.

After launching the command, the Advanced constraints options mode of the Properties panel will either open or close.

If the panel is part of a group of panels, using this command will make it the active panel in the group - bringing it to the front in docked or floating modes, and popping it out in pop-out mode.
Using this command will toggle the display of the panel in the position and mode in which it was last placed.
A currently visible panel will have a check next to its menu entry.
The panel can also be toggled with respect to its visibility, using the View » Panels » Properties command, or by clicking the Panels button (available on the right of the Status Bar) then choosing Properties.