Skip to main content

Ver: Version: 19.1

21 20.2 20.1 20.0 19.1 19.0

Close

Search Search on Documentation

Altium Designer Documentation

Documentation

Altium Designer Documentation ... Command Reference LayerStackManager Commands

LayerAdd

Created: December 04, 2018 | Updated: January 17, 2019 | Applies to versions: 19.0, 19.1, 20.0, 20.1 and 20.2

Parent page: LayerStackManager Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: Index=n (where n is in the range 0-15)

Summary

This feature is used to add a layer to the active Layer Stack.

Access

This command can be accessed from the Layer Stack by:

Choosing the Edit » Add Layer command from the main menus then selecting the desired layer type from the sub-menu.

Use

After launching the command, the selected layer will be added to the active Layer Stack.

Tips

Adding a copper layer will also add a dielectric layer when an existing adjacent layer is also a copper layer.

Note

This documentation page contains information for an older version of Altium Designer. The latest, online documentation can be found here.