CAMTASTIC_Cmd-DrillAndPlungeDrillAndPlunge_AD

Applied Parameters: CommandMode=NC

Summary

This command is used to add a drill point to the plunge point of a selected rout path in the current document.

Access

This command is accessed from the CAMtastic Editor by choosing the Place » Drill » Add Drill to Rout Plunge Point command from the main menus.

Use

After launching the command, the cursor will change to a small square and you will be prompted to select mill/rout objects that you wish to add a drill point to. Simply position the cursor over each rout path in turn, and click. Once all rout paths have been selected as required, right-click. A drill point will be added to the plunge point of each rout path.

Tips

1. The drill point will use the same drill tool that was used to define the rout path in each case.