CAMTASTIC_Cmd-DrillSymbolDrillSymbol_AD

Created: 6月 10, 2016 | Updated: 4月 11, 2017 | Applies to versions: 15.1, 16.0, 16.1, 17.0, 17.1, 18.0, 18.1, 19.0, 19.1, 20.0, 20.1, 20.2 and 21

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:

Display Drill Symbols

Applied Parameters: CommandMode=NC

Summary

This command is used to toggle the display of drill symbols in the current document. Drill symbols are used as a visual aid for easily locating drill points. A drill symbol appears as a white cross, marking the center of the drill point.

Access

This command is accessed from the CAMtastic Editor by choosing the View » Display Symbols » Drill command from the main menus.

Use

After launching the command, the display of drill symbols on the current document will either be enabled or disabled, depending on their current display status.

Tips

In order for this command to be available, make sure that you are in the NC Editor, rather than the CAM Editor. Editor selection is carried out from the View menu.