SimView_Cmd-SetCurrentAnalysisSetCurrentAnalysis_AD

Created: 6月 12, 2016 | Updated: 4月 11, 2017 | Applies to versions: 15.1, 16.0, 16.1, 17.0, 17.1, 18.0, 18.1, 19.0, 19.1, 20.0, 20.1, 20.2 and 21

Parent page: SimView Commands

The following pre-packaged resources, derived from this base command, are available:

Next Analysis Chart

Applied Parameters: Action = Next

Summary

This feature enables you to make the next available analysis chart, the current chart, in the Waveform Analysis window.

Access

This command is accessed from the SimData Editor by using the + (on the numeric keypad) keyboard shortcut.

Use

Depending on the analyses performed during the simulation, there will be a corresponding number of analyses tabs at the bottom of the Waveform Analysis window. Each tab contains a chart in which the results of analysis can be seen graphically, through the use of waveforms. Simply use this feature to make the next chart in the series (to the right), the active one. Use the feature repeatedly to cycle forward (to the right) through all available analyses charts.

Previous Analysis Chart

Applied Parameters: Action = Previous

Summary

This feature enables you to make the previous available analysis chart, the current chart, in the Waveform Analysis window.

Access

This command is accessed from the SimData Editor by using the - (on the numeric keypad) keyboard shortcut.

Use

Depending on the analyses performed during the simulation, there will be a corresponding number of analyses tabs at the bottom of the Waveform Analysis window. Each tab contains a chart in which the results of analysis can be seen graphically, through the use of waveforms. Simply use this feature to make the previous chart in the series (to the left), the active one. Use the feature repeatedly to cycle backward (to the left) through all available analyses charts.