Working with the Nets to Ignore Design Rule on a PCB in Altium Designer

Created: October 10, 2017 | Updated: September 26, 2019 | Applies to versions: 18.0, 18.1, 19.0, 19.1, 20.0, 20.1 and 20.2

Rule category: Placement

Rule classification: Unary

Summary

This rule specifies which nets should be ignored.

All design rules are created and managed within the PCB Rules and Constraints Editor dialog. For a high-level view of working with the design rules system, see Defining, Scoping & Managing PCB Design Rules.

None, the rule applies to all nets targeted by the scope (Full Query).

Contentions are not possible.

Not currently observed by the DRC tool.