DisplayInteractivePropertiesPanel

Created: December 11, 2018 | Updated: December 11, 2018 | Applies to versions: 19.0, 19.1, 20.0, 20.1 and 20.2

Parent page: InteractiveProperties Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: Action=Toggle|SetFocus=True

Summary

This command is used to quickly toggle the display of the Properties panel.

Access

This command is accessed from the Schematic Editor, Schematic Library Editor, PCB Editor, PCB Library Editor, and Layer Stackup Editor by using the F11 keyboard shortcut.

Use

After launching the command, the Properties panel will either disappear or reappear, depending on whether it is currently visible or not.

Tips

If the panel is part of a group of panels, using this command will make it the active panel in the group - bringing it to the front in docked or floating modes, and popping it out in pop-out mode.
Using this command will toggle the display of the panel in the position and mode in which it was last placed.
A currently visible panel will have a 'tick' icon next to its menu entry.
The panel can also be toggled, with respect to its visibility, using the View » Panels » Properties command, or by clicking the button (available on the right of the Status Bar) and choosing the Properties menu entry.