Skip to main content

Ver: Version: 19.1

21 20.2 20.1 20.0 19.1 19.0

Close

Search Search on Documentation

Altium Designer Documentation

Documentation

Altium Designer Documentation ... Command Reference LayerStackManager Commands

ToggleMeasurement

Created: December 04, 2018 | Updated: December 17, 2018 | Applies to versions: 19.0, 19.1, 20.0, 20.1 and 20.2

Parent page: LayerStackManager Commands

The following pre-packaged resource, derived from this base command, is available:

Cycle Through Measurement Units

Applied Parameters: None

Summary

This command is used to cycle through the measurement units in the active Layer Stack.

Access

This command can be accessed from the Layer Stack by using the Ctrl+Q keyboard shortcut.

Use

After the command is launched, the measurement units cycle between mm, in, mil, and µ. Repeatedly launch the command to select the desired units.

Note

This documentation page contains information for an older version of Altium Designer. The latest, online documentation can be found here.