LineStyleSelect

Created: August 03, 2017 | Updated: July 31, 2018 | Applies to versions: 18.0, 18.1, 19.0, 19.1, 20.0, 20.1 and 20.2

The following pre-packaged resources, derived from this base command, are available:

Applied Parameters: _Value_=Solid

Summary

This command is used to change the line style for the selected design object to Solid, where applicable.

This command is accessed from the Schematic Editor by clicking the button on the Line Style drop-down () of the Formatting toolbar.

First, ensure that the object whose line style you wish to change is selected in the main design workspace.

After launching the command, the object's line style will be set to Solid and change graphically in the workspace.

This feature will only be available if applicable to the currently selected object. That is, it has a Line Style property. Only Blanket and Polyline objects have this property.
You can select multiple objects to have their Line Style changed using this feature.

Applied Parameters: _Value_=Dashed

This command is used to change the line style for the selected design object to Dashed, where applicable.

This command is accessed from the Schematic Editor by clicking the button on the Line Style drop-down () of the Formatting toolbar.

First, ensure that the object whose line style you wish to change is selected in the main design workspace.

After launching the command, the object's line style will be set to Dashed and change graphically in the workspace.

This feature will only be available if applicable to the currently selected object. That is, it has a Line Style property. Only Blanket and Polyline objects have this property.
You can select multiple objects to have their Line Style changed using this feature.

Applied Parameters: _Value_=Dotted

This command is used to change the line style for the selected design object to Dotted, where applicable.

This command is accessed from the Schematic Editor by clicking the button on the Line Style drop-down () of the Formatting toolbar.

First, ensure that the object whose line style you wish to change is selected in the main design workspace.

After launching the command, the object's line style will be set to Dotted and change graphically in the workspace.

This feature will only be available if applicable to the currently selected object. That is, it has a Line Style property. Only Blanket and Polyline objects have this property.
You can select multiple objects to have their Line Style changed using this feature.

Applied Parameters: _Value_=Dash dotted

This command is used to change the line style for the selected design object to Dash-Dotted, where applicable.

This command is accessed from the Schematic Editor by clicking the button on the Line Style drop-down () of the Formatting toolbar.

First, ensure that the object whose line style you wish to change is selected in the main design workspace.

After launching the command, the object's line style will be set to Dash-Dotted and change graphically in the workspace.

This feature will only be available if applicable to the currently selected object. That is, it has a Line Style property. Only Blanket and Polyline objects have this property.
You can select multiple objects to have their Line Style changed using this feature.
The Dash-Dotted line style enables designs to meet GOST requirements. GOST stipulates the use of the dash-dotted line style when drawing a device on a schematic sheet (on the board it is used to show a hole's center line).