ClearFilter

Created: June 12, 2016 | Updated: April 11, 2017 | Applies to versions: 15.1, 16.0, 16.1, 17.0, 17.1, 18.0, 18.1, 19.0, 19.1, 20.0, 20.1, 20.2 and 21

Parent page: SimView Commands

The following pre-packaged resource, derived from this base command, is available:

Clear Filter

Applied Parameters: None

Summary

This command is used to clear the existing waveform filter that is currently being applied in the active analysis chart.

Access

This command can be accessed from the SimData Editor by:

Choosing the Wave » Clear Filter command from the main menus.
Using the Esc (or Shift+C) keyboard shortcut.

Use

After launching the command, the currently applied filter will be cleared and all waveforms will become fully visible again in the Waveform Analysis window. The previously selected waveform, on whose name the scope of the applied filter was based, will become deselected.

Tips

The current filter can also be cleared by using the Clear button, located at the bottom-right of the Waveform Analysis window.