SnapChange

Created: June 11, 2016 | Updated: April 11, 2017 | Applies to versions: 15.1, 16.0, 16.1, 17.0, 17.1, 18.0, 18.1, 19.0, 19.1, 20.0, 20.1, 20.2 and 21

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:

Toggle Snapping

Applied Parameters: None

Summary

This command is used to toggle between the Off snap mode and the previously selected snap mode (other than Off).

Access

This command can be accessed from the CAMtastic Editor by:

Right-clicking within the main workspace and choosing the Snap Change command from the context menu.
Right-clicking, while placing a polyline object, and choosing Snap Change from the context menu.
Using the Shift+S keyboard shortcut.

Use

After launching the command, the snap mode will either become Off, or the previously selected mode, depending on the current state.

Tips

The current snap mode can be viewed/changed on the CAMtastic panel, and also on the CAM Editor - Drawing Modes page of the Preferences dialog.