Skip to main content

Ver: Version: 19.0

21 20.2 20.1 20.0 19.1 19.0

Close

Search Search on Documentation

Altium Designer Documentation

Documentation

Altium Designer Documentation ... Command Reference LayerStackManager Commands

LoadTemplateFromFile

Created: December 04, 2018 | Updated: December 17, 2018 | Applies to versions: 19.0, 19.1, 20.0, 20.1 and 20.2

Parent page: LayerStackManager Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: None

Summary

This command is used to load a stackup template from a file.

Access

This command can be accessed from the Layer Stack by choosing File » Load Template from the main menus.

Use

After launching the command, the Open Stackup Document dialog opens. Select the desired template then click Open to open the stackup template.

Note

This documentation page contains information for an older version of Altium Designer. The latest, online documentation can be found here.