Skip to main content

Ver: Version: 19.0

21 20.2 20.1 20.0 19.1 19.0

Close

Search Search on Documentation

Altium Designer Documentation

Documentation

Altium Designer Documentation ... Command Reference LayerStackManager Commands

OpenPreset

Created: December 04, 2018 | Updated: December 17, 2018 | Applies to versions: 19.0, 19.1, 20.0, 20.1 and 20.2

Parent page: LayerStackManager Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: Index=n (where n is in the range 0-9)

Summary

This command is used to select a pre-defined number and types of layers for the layer stackup.

Access

This command can be accessed from the Layer Stack by choosing Tools » Presets from the main menus then selecting the desired preset.

Use

After launching the command, the Layer Stack will display the chosen number and types of layers.

Note

This documentation page contains information for an older version of Altium Designer. The latest, online documentation can be found here.