Skip to main content

Ver: Version: 19.0

21 20.2 20.1 20.0 19.1 19.0

Close

Search Search on Documentation

Altium Designer Documentation

Documentation

Altium Designer Documentation ... Command Reference LayerStackManager Commands

SwitchMeasurement

Created: December 04, 2018 | Updated: December 17, 2018 | Applies to versions: 19.0, 19.1, 20.0, 20.1 and 20.2

Parent page: LayerStackManager Commands

The following pre-packaged resource, derived from this base command, is available:

Switch Measurement Units

Applied Parameters: Index=n (where n is in the range 0-9)

Summary

This command is used to change the measurement units in the active Layer Stack.

Access

This command can be accessed from the Layer Stack by choosing Tools » Measurement Units then selecting the desired unit of measure. Choose from mil, in, µ, and mm.

Use

After the command is launched, the measurement units in the Layer Stack change to the unit that was selected.

Note

This documentation page contains information for an older version of Altium Designer. The latest, online documentation can be found here.