Skip to main content

Ver: Version: 19.0

21 20.2 20.1 20.0 19.1 19.0

Close

Search Search on Documentation

Altium Designer Documentation

Documentation

Altium Designer Documentation ... Command Reference MultiBoardAssembly Commands

OpenMateProperties

Created: December 11, 2018 | Updated: December 12, 2018 | Applies to versions: 19.0, 19.1, 20.0, 20.1 and 20.2

Parent page: MultiBoardAssembly Commands

The following pre-packaged resources, derived from this base command, are available:

Access Mate Properties

Applied Parameters: None

Summary

This feature is used to access the Properties panel in Mate mode in a Multi-Board Assembly document (*.MbaDoc).

For a high-level look at multi-board design within Altium Designer, see Designing Systems with Multiple Boards.

Access

This command can be accessed from the Multi-Board Assembly editor by right-clicking on a Mate entry in the Multiboard Assembly panel then choosing Properties.

Use

After launching the command, the Properties panel opens in Mate mode.

Note

This documentation page contains information for an older version of Altium Designer. The latest, online documentation can be found here.