Skip to main content

Ver: Version: 19.0

22 21 20.2 20.1 20.0 19.1 19.0 18.1 18.0 17.1 17.0 16.1 16.0 15.1

Close

Search Search on Documentation

Altium Designer Documentation

Documentation

Altium Designer Documentation ... Command Reference PCB Commands

ResetOrigin

Created: July 27, 2015 | Updated: July 17, 2018 | Applies to versions: 15.1, 16.0, 16.1, 17.0, 17.1, 18.0, 18.1, 19.0, 19.1, 20.0, 20.1, 20.2 and 21

Parent page: PCB Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: None

Summary

This command is used to set the relative origin back to the default absolute origin at the extreme lower-left of the document workspace.

Access

This command is accessed from the PCB Editor by choosing the Edit » Origin » Reset command from the main menus.

Use

After launching the command, the absolute origin - at the lower-left of the document workspace - will become restored with coordinates (0,0).

Tips

Once the absolute origin has been restored, the screen will refresh and all design objects will have their locations recalculated, relative to this default origin.

Note

This documentation page contains information for an older version of Altium Designer. The latest, online documentation can be found here.