Skip to main content

Ver: Version: 18.1

22 21 20.2 20.1 20.0 19.1 19.0 18.1 18.0 17.1 17.0 16.1 16.0 15.1

Close

Search Search on Documentation

Altium Designer Documentation

Documentation

Altium Designer Documentation ... Command Reference CAMtastic Commands

PolylineUndo

Created: June 11, 2016 | Updated: April 11, 2017 | Applies to versions: 15.1, 16.0, 16.1, 17.0, 17.1, 18.0, 18.1, 19.0, 19.1, 20.0, 20.1, 20.2 and 21

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:

Polyline - Undo Changes

Applied Parameters: None

Summary

This command is used to clear the entire polyline object that you are currently placing in the current document, effectively allowing you to start placement afresh.

Access

This command is accessed from the CAMtastic Editor, when placing a polyline, by right-clicking and choosing the Undo Polyline Changes command from the context menu.

Use

After launching the command, the polyline object currently being placed will be cleared. You will remain in polyline placement mode, enabling you to start placement of a new polyline.

Note

This documentation page contains information for an older version of Altium Designer. The latest, online documentation can be found here.