ManageLayerSets

Created: July 28, 2017 | Updated: August 02, 2021 | Applies to versions: 18.0, 18.1, 19.0, 19.1, 20.0, 20.1, 20.2 and 21

Parent page: PCB Commands

The following pre-packaged resource, derived from this base command, is available:

Layer Set

Applied Parameters: SetIndex=n (where n is in the range 0 to 20)

Summary

This command is used to switch to the indicated layer set.

Access

The related indexed commands are available from the PCB Editor from the Design » Manage Layer Sets sub-menu.

In addition, from both PCB and PCB Library Editors, the indexed commands are available from the context menu associated with the Layer Set control - accessed by clicking the LS part of the button to the left of the layer tabs at the bottom of the main design window.

Use

After launching the command, the indicated layer set is made the current layer set with only its member layers presented visibly in the design space.

Tip

Layer sets can be managed through the Layers section on the Layers & Colors tab of the View Configuration panel.