InspectReportsDrill

Created: June 10, 2016 | Updated: April 11, 2017 | Applies to versions: 15.1, 16.0, 16.1, 17.0, 17.1, 18.0, 18.1, 19.0, 19.1, 20.0, 20.1, 20.2 and 21

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:

Generate Drill Report

Applied Parameters: None

Summary

This command is used to generate a drill report for the current document.

Access

This command is accessed from the CAMtastic Editor by choosing the Reports » Drill command from the main menus.

Use

After launching the command, a drill report (Drill.rpt) will be generated and opened as the active document in the main design window. The report lists, for each drill tool that has been defined, the drill size and the number of drill points existing in the design document.

Tips

The report is generated and saved automatically in the \Users\<ProfileName>\AppData\Roaming\Altium\Altium Designer <GUID>\CAMtastic folder of your software installation. The report will appear in the Projects panel as a free document.
All measurement information uses the current units for the workspace - either inches or millimeters. Units can be changed either from the CAMtastic panel, or the CAM Editor - Drawing Modes page of the Preferences dialog.
Generating a new report will overwrite an existing report of the same name without warning.