SelmenuRemove

Created: June 11, 2016 | Updated: April 11, 2017 | Applies to versions: 15.1, 16.0, 16.1, 17.0, 17.1, 18.0, 18.1, 19.0, 19.1, 20.0, 20.1, 20.2 and 21

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:

Set Selection Mode to Remove

Applied Parameters: None

Summary

This command is used to set the selection mode to Remove, allowing you to remove objects from the current selection.

Access

This command can be accessed from the CAMtastic Editor by:

Choosing the Edit » Selection » Remove command from the main menus.
Clicking the button, on the Miscellaneous Tools drop-down () of the Utilities toolbar.

Use

After launching the command, the selection mode will be set to Remove. You are now free to remove objects from your current selection, simply by positioning the cursor over individual objects and clicking, or by dragging a selection box around a group of objects.

Tips

You must be in editing mode (carrying out an editing operation), before this command will become available.
The objects that can be removed will depend on the selection modes enabled - Flash/Point and/or Draws.