RemoveWave

Created: June 12, 2016 | Updated: April 11, 2017 | Applies to versions: 15.1, 16.0, 16.1, 17.0, 17.1, 18.0, 18.1, 19.0, 19.1, 20.0, 20.1, 20.2 and 21

Parent page: SimView Commands

The following pre-packaged resource, derived from this base command, is available:

Remove Wave from Plot

Applied Parameters: None

Summary

This command is used to remove the selected waveform from the active wave plot, in the current chart of the Waveform Analysis window.

Access

This command can be accessed from the SimData Editor by:

Choosing the Wave » Remove Wave command from the main menus.
Clicking the button on the SimView toolbar.
Right-clicking on the waveform's name and choosing the Remove Wave command from the context menu.

Use

First, ensure that the waveform you wish to remove is selected in the Waveform Analysis window. This is achieved by clicking on the waveform name (a selected waveform will become bolder in color and have a dot to the left of its name).

Launch the command - the waveform will be removed from the plot.

Tips

The selected waveform can also be removed from the active wave plot by using the Delete command.
When a waveform is selected, filtering is applied, using the name of the waveform as the scope. All other waveforms in the active chart with different names will be masked (becoming dimmed). The extent of the masking - how dimmed the non-selected waveforms become - can be controlled through the use of the Mask Level slider bar, accessed by clicking the Mask Level button, located at the bottom-right of the Waveform Analysis window. If more than one waveform of the same name exists in the active chart, the non-selected instances will remain fully visible.