Skip to main content

Ver: Version: 17.0

22 21 20.2 20.1 20.0 19.1 19.0 18.1 18.0 17.1 17.0 16.1 16.0 15.1

Close

Search Search on Documentation

Altium Designer Documentation

Documentation

Altium Designer Documentation ... Command Reference CAMtastic Commands

PolylineLineMode

Created: June 11, 2016 | Updated: April 11, 2017 | Applies to versions: 15.1, 16.0, 16.1, 17.0, 17.1, 18.0, 18.1, 19.0, 19.1, 20.0, 20.1, 20.2 and 21

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:

Polyline - Change to Line Placement Mode

Applied Parameters: None

Summary

This command is used to change from drawing arcs to drawing lines, while placing a polyline object in the current document.

Access

This command is accessed from the CAMtastic Editor, when placing a polyline, by right-clicking and choosing the Change to Line command from the context menu.

Use

After launching the command, the current mode for polyline placement will change to line, and a line segment will appear extending from the last vertex point placed.

Note

This documentation page contains information for an older version of Altium Designer. The latest, online documentation can be found here.