WindowToggleMenu

Created: June 11, 2016 | Updated: April 11, 2017 | Applies to versions: 15.1, 16.0, 16.1, 17.0, 17.1, 18.0, 18.1, 19.0, 19.1, 20.0, 20.1, 20.2 and 21

Parent page: CAMtastic Commands

The following pre-packaged resources, derived from this base command, are available:

Switch to NC Editor

Applied Parameters: CommandMode=CAM

Summary

This command is used to change the current Editor for the document to the NC Editor.

Access

This command is accessed from the CAMtastic Editor by choosing the View » NC Editor command from the main menus.

Use

After launching the command, the current Editor will become the NC Editor. This Editor needs to be selected before any drilling/routing commands are available.

Tips

If the command is not available, the NC Editor is already the current Editor for the document.

Switch to CAM Editor

Applied Parameters: CommandMode=NC

Summary

This command is used to change the current Editor for the document to the CAM Editor.

Access

This command is accessed from the CAMtastic Editor by choosing the View » CAM Editor command from the main menus.

Use

After launching the command, the current Editor will become the CAM Editor.

Tips

If the command is not available, the CAM Editor is already the current Editor for the document.