RemovePlot

Created: June 12, 2016 | Updated: April 11, 2017 | Applies to versions: 15.1, 16.0, 16.1, 17.0, 17.1, 18.0, 18.1, 19.0, 19.1, 20.0, 20.1, 20.2 and 21

Parent page: SimView Commands

The following pre-packaged resource, derived from this base command, is available:

Delete Plot

Applied Parameters: None

Summary

This command is used to delete the active wave plot from the current chart in the Waveform Analysis window.

Access

This command can be accessed from the SimData Editor by:

Choosing the Plot » Delete Plot command from the main menus.
Right-clicking within the active plot and choosing the Delete Plot command from the context menu.

Use

First, ensure the wave plot that you wish to delete is made active in the waveform analysis window. This is achieved by clicking anywhere within the area of the wave plot.

Launch the command - the entire wave plot, and any waveforms contained therein, will be deleted.

Tips

If the Number of Plots Visible option is set to All in the Document Options dialog (Tools » Document Options), the active wave plot is distinguished by a black solid line around its waveform name section. If the Number of Plots Visible option is set to 1, 2, 3, or 4, the active wave plot is distinguished by a black arrow at the left hand side of its display area.
If you wish to delete an individual waveform from a wave plot, make sure the required waveform is selected and use either the Delete command, or the Remove Wave command. Waveform selection is achieved by clicking on the waveform name (a selected waveform will become bolder in color and have a dot to the left of its name).
If you want to remove all waveforms but leave the empty plot intact, use the Clear command.