GroupResizeTracks

Applied Parameters: None

Summary

This command is used to move the end-points of multiple selected track segments, effectively resizing the segments.

Access

This command is accessed from the PCB Editor by choosing the Edit » Move » Move / Resize Tracks command, from the main menus.

Use

First ensure the track segments whose end-points you wish to move are selected in the workspace.

After launching the command, the cursor will change to a cross-hair, and you will be prompted to choose a track end-point. To move/resize the tracks:

1. Position the cursor on the end-point of one of the segments in the selection and click or press Enter.
2. Move the cursor - all of the track segments in the selection will resize dynamically, while maintaining original distances and angles between each other. The other end of each segment will rubber-band to maintain its existing connection/location.
3. Once the segments are in the desired location, click or press Enter to effect placement and exit movement mode.
4. To cancel out of the operation, simply right-click or press Esc.

While moving the segments around, the following additional controls are available:

• Press the Tab key to cycle the cursor between the end-point of each track segment in the selection.
• Hold the Alt key while moving to constrain movement in a particular direction, dependent on initial direction moved. Horizontal, vertical and 45 degree angle directions are possible.
• Press the Spacebar twice to quickly make all end-points of the track segments in-line with each other, in either the horizontal, or vertical planes. Press Spacebar twice quickly again to return to the previous sizing.

Tips

1. This command can also be used to move the end-point of a single, un-selected track segment. Note that only the Alt key additional control can be used in this case.