MCAD Fusion 360: Bad performance with the boards with 500+ components

Created: 23.09.2021 | Updated: 23.09.2021

This is a known issue with Fusion (reported for all big assemblies, not only with the ones built by CoDesigner.)

Starting in Version: 20.1
Up to Version: Current

Solution Details

As an alternative approach, we provide a way to disable the placement of small components (in most cases, they are not important for the mechanical design). See this documentation: https://www.altium.com/documentation/altium-designer/new-in-codesigner-ad#!support-for-fusion-360-to-ignore-small-components
Was this article helpful?
0
0
Обнаружили проблему в этом документе? Выделите область и нажмите Ctrl+Enter, чтобы оповестить нас.

Связаться с нами

Связаться с нашими Представительствами напрямую

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
Вы сообщаете о проблеме, связанной со следующим выделенным текстом
и/или изображением в активном документе: