Parent page: Schematic Commands
The following pre-packaged resource, derived from this base command, is available:
Convert Cross Junctions
Applied Parameters: None
Summary
This command is used to quickly convert a 4-way auto-generated junction (created with wire or bus objects), into two adjacent 3-way auto-generated junctions.
Access
This command is accessed in the Schematic Editor only, by choosing the Tools » Convert » Convert Cross Junctions command from the main menus.
Use
After launching the command, the Junctions Conversion dialog will appear. Use this dialog to determine the scope of the conversion (current document, project documents, or all open schematic documents), and whether all potential 4-way junctions are considered, or only those associated to selected wires/busses in the target documents. Once conversion options are configured as desired, clicking OK in the dialog will effect conversion.
Tips
- When converting based on selected objects, you must select all wire (or bus) segments that enter the 4-way junction.