Altium NEXUS Documentation

RunERC

Created: October 4, 2017 | Updated: October 4, 2017

Parent page: WorkspaceManager Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: ObjectKind=Document

Summary

This command is used to run an electrical rules check (ERC) on the active Multi-board Schematic document, checking for violations concerning the connections between the modules on the sheet, as well as problems associated with mated parts.

For a high-level look at multi-board design within Altium NEXUS, see Designing Systems with Multiple Boards.

Access

This command is accessed from the Multi-board Schematic Editor by choosing the Design » Run ERC command, from the main menus.

Use

After launching the command, the ERC will be run. Any issues will be flagged as entries in the Messages panel.

Tips

  1. The Compiler uses the options defined on the Error Reporting tab of the Options for Project dialog, when checking for violations.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: