Altium Designer Documentation

DrawCircle2P

Created: June 10, 2016 | Updated: April 11, 2017

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: CommandMode=CAM

Summary

This command is used to place circle objects onto the current document. The circle is drawn using two opposite points on the circumference, whose distance defines the diameter of the circle.

Access

This command is accessed from the CAMtastic Editor by choosing the Place » Circle » 2-Points command from the main menus.

Use

After launching the command, you will enter circle placement mode. Placement is made by performing the following sequence of actions:

  1. Position the cursor at the required position and click to define the first point on the circumference.
  2. Move the cursor to define the second point on the circumference. As you move the cursor, a line appears to visually define the diameter of the circle, the midpoint of which will be the circle's center. When the diameter is as required, click to define the second circumference point and complete placement of the circle.
  3. Continue placing further circles or right-click, or press Esc, to exit circle placement mode.

Tips

  1. Circles will be drawn using the current DCode. Set the required DCode in the DCode field on the CAMtastic panel.
  2. Circles will be drawn on the current layer. The current layer is displayed on the CAMtastic panel at the top of the layers list. Double-clicking on any layer in the layers list will cause it to become the current layer.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: