Altium Designer Documentation

DrawCircleCenRad2

Created: June 10, 2016 | Updated: April 11, 2017

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: CommandMode=CAM

Summary

This command is used to place circle objects onto the current document. The circle is drawn using a center point and a numerically defined radius.

Access

This command is accessed from the CAMtastic Editor by choosing the Place » Circle » Center, Radius command from the main menus.

Use

After launching the command, you will enter circle placement mode. Placement is made by performing the following sequence of actions:

  1. Position the cursor at the required position and click to define the center point for the circle.
  2. The Enter Value dialog will appear, prompting you to enter a value for the radius. After specifying the radius required, click OK to complete placement of the circle.
  3. Continue placing further circles or right-click, or press Esc, to exit circle placement mode.

Tips

  1. The radius entered will use the current units for the workspace - either inches or millimeters. Units can be changed either from the CAMtastic panel, or from the CAM Editor - Drawing Modes page of the Preferences dialog.
  2. Circles will be drawn using the current DCode. Set the required DCode in the DCode field on the CAMtastic panel.
  3. Circles will be drawn on the current layer. The current layer is displayed on the CAMtastic panel at the top of the layers list. Double-clicking on any layer in the layers list will cause it to become the current layer.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: