Altium Designer Documentation


Created: June 10, 2016 | Updated: April 11, 2017

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: CommandMode=NC


This command is used to add a drill point to the plunge point of a selected rout path in the current document.


This command is accessed from the CAMtastic Editor by choosing the Place » Drill » Add Drill to Rout Plunge Point command from the main menus.


After launching the command, the cursor will change to a small square and you will be prompted to select mill/rout objects that you wish to add a drill point to. Simply position the cursor over each rout path in turn, and click. Once all rout paths have been selected as required, right-click. A drill point will be added to the plunge point of each rout path.


  1. The drill point will use the same drill tool that was used to define the rout path in each case.


Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: