Altium Designer Documentation

EditAlignBorder

Created: June 10, 2016 | Updated: April 11, 2017

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to align layers in the current document, based on matching layer boundaries.

Access

This command is accessed from the CAMtastic Editor by choosing the Edit » Layers » Align Border (Auto-Detect) command from the main menus.

Use

After launching the command, the cursor will change to a square and you will enter alignment mode. You will be prompted to select a closed border. Simply position the cursor over an edge of the border for the target layer that you wish to align all other matching layers to, and click. All layers that contain a matching border will be aligned to the target layer.

Continue aligning layers by border, or right-click, or press Esc, to exit alignment mode.

Tips

  1. Any layers where no matching border is detected will be left alone.
  2. The selected border should be a straight edge of a closed boundary.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: