Altium Designer Documentation

InfoPolygons

Created: June 11, 2016 | Updated: April 11, 2017

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to locate any invalid polygons within the current document. Polygons in a CAM document are continuous outlined boundaries that are Raster filled. Raster-filled boundaries cannot support overlapping or multiple shared vertices. Such instances are deemed invalid polygons and, if left unchecked, could cause undesirable results when photoplotting.

Access

This command is accessed from the CAMtastic Editor by choosing the Analysis » Invalid Polygon Search command from the main menus.

Use

After launching the command the cursor will change to a small square and you will be prompted to "Select Draws". Simply drag a selection box around polygons in the design or, more efficiently, drag the selection box around the entire design. Once the selection is made, right-click. An information dialog will appear, either stating that No Invalid Polygons were Found, or that n Invalid Polygons were Found. In the latter case, the offending polygons will be assigned to the next unused Dcode and will become unfilled in the main design workspace.

Tips

  1. You can restore an invalid polygon by using the Undo command.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: