Altium Designer Documentation

PolylineClockwise

Created: June 11, 2016 | Updated: April 11, 2017

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to set the arc drawing direction to clockwise, when placing a polyline, and in arc mode.

Access

This command is accessed from the CAMtastic Editor, when placing a polyline, by right-clicking and choosing the Draw Arc Clockwise command from the context menu.

Use

After launching the command, the current arc segment being placed for the current polyline will be drawn in the clockwise direction.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: