Altium Designer Documentation


Created: June 11, 2016 | Updated: April 11, 2017

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: None


This command is used to access the Tool Table dialog, from where you can define the drill/mill/rout tools that are available for use in the current document.


This command is accessed from the CAMtastic Editor by choosing the Tables » NC Tools command from the main menus.


After launching the command, the Tool Table dialog will appear. By default, the table will contain a list of tools based on any imported NC Drill file, otherwise it will appear empty. Use the table to add/edit tool definitions. Up to 99 tools can be defined, each with a unique Dcode, starting from D9500.

Use the Save and Open buttons to save the current tool table definition, or load a previously saved definition, respectively. Tool data is stored in a Mill/Rout Table Settings file (*.mts).


  1. Hovering within the various columns of the table grid will cause a tool tip to appear, with more information about that entry .


Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: