Altium Designer Documentation


Created: June 11, 2016 | Updated: April 11, 2017

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: CommandMode=NC


This command is used to toggle the display of the original centerline of the rout path - the path with no cutter compensation offset applied.


This command is accessed from the CAMtastic Editor by choosing the View » Display Symbols » Centerline Path command from the main menus.


After launching the command, the display of the original centerline path for rout paths in the design will be toggled ON or OFF, depending on the current status. The centerline path is a solid line and shows the rout path that is taken if no cutter compensation offset is applied.


  1. The effect of this command is noticeable only when the Fill mode is turned OFF.


Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: