Altium Designer Documentation

WindowToggleMenu

Created: June 11, 2016 | Updated: April 11, 2017

Parent page: CAMtastic Commands

The following pre-packaged resources, derived from this base command, are available:


Applied Parameters: CommandMode=CAM

Summary

This command is used to change the current Editor for the document to the NC Editor.

Access

This command is accessed from the CAMtastic Editor by choosing the View » NC Editor command from the main menus.

Use

After launching the command, the current Editor will become the NC Editor. This Editor needs to be selected before any drilling/routing commands are available.

Tips

  1. If the command is not available, the NC Editor is already the current Editor for the document.


Applied Parameters: CommandMode=NC

Summary

This command is used to change the current Editor for the document to the CAM Editor.

Access

This command is accessed from the CAMtastic Editor by choosing the View » CAM Editor command from the main menus.

Use

After launching the command, the current Editor will become the CAM Editor.

Tips

  1. If the command is not available, the CAM Editor is already the current Editor for the document.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: