Altium Designer Documentation

ResetOrigin

Created: July 27, 2015 | Updated: July 17, 2018

Parent page: PCB Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to set the relative origin back to the default absolute origin at the extreme lower-left of the document workspace.

Access

This command is accessed from the PCB Editor by choosing the Edit » Origin » Reset command from the main menus.

Use

After launching the command, the absolute origin - at the lower-left of the document workspace - will become restored with coordinates (0,0).

Tips

  1. Once the absolute origin has been restored, the screen will refresh and all design objects will have their locations recalculated, relative to this default origin.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: