Altium NEXUS Documentation

SelmenuRemove

Created: 11.06.2016 | Updated: 11.04.2017

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to set the selection mode to Remove, allowing you to remove objects from the current selection.

Access

This command can be accessed from the CAMtastic Editor by:

  • Choosing the Edit » Selection » Remove command from the main menus.
  • Clicking the  button, on the Miscellaneous Tools drop-down () of the Utilities toolbar.

Use

After launching the command, the selection mode will be set to Remove. You are now free to remove objects from your current selection, simply by positioning the cursor over individual objects and clicking, or by dragging a selection box around a group of objects.

Tips

  1. You must be in editing mode (carrying out an editing operation), before this command will become available.
  2. The objects that can be removed will depend on the selection modes enabled - Flash/Point and/or Draws.

 

Обнаружили проблему в этом документе? Выделите область и нажмите Ctrl+Enter, чтобы оповестить нас.

Связаться с нами

Связаться с нашими Представительствами напрямую

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
Вы сообщаете о проблеме, связанной со следующим выделенным текстом
и/или изображением в активном документе: