Altium NEXUS Documentation


Created: 23.09.2017 | Updated: 23.09.2017
Вы просматриваете версию 3.2. Для самой новой информации, перейдите на страницу для версии 5

Parent page: WorkspaceManager Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: ObjectKind=OutputPreferences


This command is used to configure the properties of the currently selected output container, or print job, in the active Output Job Configuration file.


With the required output container/print job selected, this command can be accessed from the OutputJob Editor by:

  • Choosing the Tools » Container Setup command, from the main menus.
  • Using the Ctrl+Shift+O keyboard shortcut.


First, ensure that the output container/print job that you wish to configure is selected, in the Output Containers region, or Hard Copy region of the main job configuration window, respectively.

After launching the command, the applicable settings dialog will appear. Use the dialog to manage and configure the properties of the selected output container/print job, which will be applied when generating output from its linked output generators.


  1. The associated settings dialog can also be accessed by clicking on the Change link, at the top-right of the container/print job's entry in the Output Containers/Hard Copy region.


Обнаружили проблему в этом документе? Выделите область и нажмите Ctrl+Enter, чтобы оповестить нас.

Связаться с нами

Связаться с нашими Представительствами напрямую

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
Вы сообщаете о проблеме, связанной со следующим выделенным текстом
и/или изображением в активном документе: