Altium Designer Documentation

RemoveMate

Using Altium Documentation
Created: December 5, 2018 | Updated: December 12, 2018
Now reading version 20.1. For the latest, read: RemoveMate for version 21
Applies to Altium Designer versions: 19.0, 19.1, 20.0, 20.1 and 20.2

Parent page: MultiBoardAssembly Commands

The following pre-packaged resources, derived from this base command, are available:

Remove Mate


Applied Parameters: None

Summary

This feature is used to remove a Mate. 

For a high-level look at multi-board design within Altium Designer, see Designing Systems with Multiple Boards.

Access

This command can be accessed by right-clicking on a Mate entry in the Multiboard Assembly panel then choosing Remove Mate.

Use

After launching the command, the Mate will be removed.

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

Contact Us Now
We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: