Parent page: PCB Commands
The following pre-packaged resource, derived from this base command, is available:
Applied Parameters: None
This command is used to clear the selected object(s) from the current document and copy them to the clipboard.
This command can be accessed from the PCB Editor, the PCB Library Editor, and the Pad Via Library Editor by:
Make sure that the object(s) that you want to cut are selected then launch the command. The cursor will change to a crosshair and you will be prompted to select a reference point. This is a coordinate relative to the selected object(s) and is used to accurately position the selection when using the paste command. Position the cursor as required then click or press Enter; the selection will be removed from the workspace and copied to the clipboard.
The features available depend on your level of Altium Designer Software Subscription.