Setup Paste Array (PCB)

Created: August 4, 2017 | Updated: June 7, 2021

Contents

Summary
Access
Options/Controls

The Setup Paste Array dialog

Summary

The Setup Paste Array dialog provides options for pasting a linear or circular array of the current clipboard contents. For example, you can use the Paste Array feature to paste an alpha-numerically designated array of pads for a BGA.

Access

The dialog can be accessed by clicking the Paste Array button in the Paste Special dialog (Edit » Paste Special).

Options/Controls

Placement Variables

Item Count - the number of repeat placements to be performed. For example, typing 4 will place 4 copies of the current clipboard contents.
Text Increment - enter the automatic increment for the display text (e.g., component or pad designator). Both alpha and numeric increments other than 1 are supported. For example, by setting the designator of a pad prior to copying it to the clipboard and setting the Text Increment field, the following types of pad designator sequences can be placed:
- Numeric (1, 3, 5)
- Alphabetic (A, B, C)
- Combination of alpha and numeric (A1, A2, or 1A, 1B, or A1, B1 or 1A, 2A, etc)

To increment numerically, set the Text Increment field to the amount you wish to increment by.
To increment alphabetically, set the Text Increment field to the letter in the alphabet that represents the number of letters you wish to skip. For example, if the initial pad had a designator of 1A and the Text Increment field was set to C (the third letter of the alphabet), the pads would have the designators 1A, 1D (three letters after A), 1G (three letters after D), and so on.
Note that the last-used incremental value is remembered after pasting an array, the next value in that sequence will be used as the base value of the next array that you paste, unless you perform a new Copy action.

Array Type

Circular- enable this option to paste a circular array, using the current Circular Array settings.
Linear - enable this option to paste the array in a straight line, using the current Linear Array settings.

Circular Array

Rotate Item to Match - if enabled, array items will be rotated by the same angular amount as their Spacing.
Spacing (degrees) - the angular space between two adjacent pasted items.

Linear Array

X-Spacing - enter the desired X space between two adjacent items.
Y- Spacing - enter the desired Y space between two adjacent items.

When you paste the array, it will be held by the same reference location that was used when the Copy action was performed.

Printer-friendly version

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.