Parent page: Schematic Commands
The following pre-packaged resource, derived from this base command, is available:
Applied Parameters: None
This command is used to clear the selected object(s) from the current document and copy them to the clipboard.
This command can be accessed from the Schematic Editor and the Schematic Library Editor by:
Make sure that the object(s) that you want to cut is selected then launch the command. If the Clipboard Reference option is enabled on the Schematic - Graphical Editing page of the Preferences dialog, the cursor will change to a crosshair and you will be prompted to select a reference point. This is a coordinate relative to the selected object(s) and is used to accurately position the selection when using the paste command. If the Clipboard Reference option is disabled, the current cursor position is used as the reference point.
If you require the sheet template to be added as part of the copy (containing border, title block, etc.,), make sure that the Add Template to Clipboard option is enabled on the Schematic - Graphical Editing page of the Preferences dialog.
Position the cursor as required and click or press Enter - the selection will be removed from the workspace and copied to the clipboard.
The features available depend on your level of Altium Designer Software Subscription.